Holds the magnet used to trigger the screen sensors.
Use the mounting template (provided in the box) to mark holes.
Verify that the unit is level and firmly anchored to prevent mechanical stress on the conduit entries. 3. Electrical Connections and Wiring Xnx Universal Transmitter Quick Start Guide
If you need help troubleshooting specific errors during your setup, please let me know:
Never open the enclosure when an explosive atmosphere is present unless you have a valid hot work permit. Holds the magnet used to trigger the screen sensors
: Install the housing with the main sensor port pointing downward to prevent water or dust accumulation on the sensor element.
: Once readings stabilize, select Confirm to save the new span factor. : Once readings stabilize, select Confirm to save
Set the current date and time to ensure accurate internal data logging. Step 2: Zero Calibration (Fresh Air Baseline)
Wire the for the 4-20mA analog loop signal output.
Before wiring the XNX, always power off the transmitter. Key points include:
: Enter the default passcode 0000 using [ ▲ ] or [ ▼ ] .